top of page

GASKETING PRODUCTS

FERRATEX 25 Sheet

Gasket made from FERRATEX 25 cloth. 100% fiberglass yarns are reinforced with several strands of stainless steel wire. The yarn is woven into FERRATEX 25 cloth per HH-P-0031. Several layers of cloth are then specifically bonded together to obtain desired thickness.

APPLICATIONS

  • Gasket applications with elevated temperatures

  • Engine exhause gaskets

  • Incinerator flange gaskets

  • Ventilation duct heater flange gaskets

  • High-temperature washers, ferrules, and spacers

 

FEATURES/BENEFITS

  • Approved substitute for asbestos sheet gaskets

  • Tested on gas turbine exhaust: operated for 7528 hours without any leaks or degradation

  • Tested on diesel engile exhaust: operated for 800 hours without any leaks or degradation

  • Extremely durable

  • High degree of abrasion resistance

  • Can withstand elevated service temperatures

AVAILABLE SIZES

  • Thicknesses: 1/16" , 1/8" , 1/4" , and 3/8"

  • Standard sheet sizes: 48" x 60" and 60" x 60"

Ferratex 25 MSDS

ROTEX 10 Gasketing Sheet

A high-density material with low compressibility and high tensile strength. It is a blend of chloroprene latex and high-temperature reinforcement materials. A homogenous gasketing material that is produced by a wet process, thus yielding an extremely uniform sheet.

APPLICATIONS

  • Flanges requiring high loads at elevated temperatures

  • Recommended for:

    • Sealing oils​

    • Fuels

    • Halogen gaskets

    • Water & steam

    • Freon systems

FEATURES/BENEFITS

  • Withstands high flange loads and temperatures up to 750° F

  • Asbestos free

  • High tensile strength

  • Approved by U.S. Navy for many gasket applications

  • Low compressibility/crush resistant

  • Gaskets exhibit clean cut edges and good thickness uniformity

  • Good sealability

AVAILABLE SIZES

  • Thicknesses: 1/64" , 1/32" , 1/16" , and 1/8"

  • Standard sheet sizes: 65" x 70" , 1/64" available only in 32-1/2" x 70"

Rotex Gasketing Sheet Technical Data

Rotex MSDS

ROTEX 20 Gasketing Sheet

​A high-density material with low compressibility and high tensile strength. It is a blend of nitrile latex and high-temperature reinforcement materials. A homogenous gasketing meterial that is produced by a wet process, thus yielding an extremely uniform sheet.

APPLICATIONS

  • Flanges requiring high loads at elevated temperatures

  • Recommended for:

    • Hot oils​

    • Petroleum solvents

    • Gasoline

    • Other aromatics

FEATURES/BENEFITS

  • Withstands high flange loads at temperatures up to 800° F

  • Asbestos free

  • Approved by U.S. Navy for many gasket applications

  • High tensile strength

  • Low compressibility/crush resistent

  • Gaskets exhibit clean cut edges and good thickness uniformity

  • Good sealability

AVAILABLE SIZES

  • Thicknesses: 1/64" , 1/32" , 1/16" , and 1/8"

  • Standard sheet sizes: 65" x 70" , 1/64" available only in 32-1/2" x 70"

bottom of page